Toyota kluger intermediate steering shaft




Toyota kluger intermediate steering shaft

Article Navigation:
  • Photo
  • TOYOTA OEM Highlander Steering Intermediate Shaft for sale online | eBay
  • Video
  • RELATED PAGES
  • I am on my third Toyota Kluger and until now I could not fault them, but my The clunking is coming from the intermediate steering shaft sliding.

    If you own a Toyota Highlander vehicle, you may have noticed a clunk, pop, or knock-type noise when turning the steering wheel left or right. Below are just a few of the multitude of complaints describing the clunking, popping, and/or rattling noise consumers experience.

    Something called an intermediate steering shaft. I have Toyota Kluger bought in Nov and I have noticed after KM the steering.

    Toyota kluger intermediate steering shaft

    Toyota kluger intermediate steering shaft

    Related Sites Related Sites. Header link Heather King. Remove the steering wheel holder from the vehicle if used. June 15, Heather King. It can be scary when your steering system makes unexpected noises.

    Toyota kluger intermediate steering shaft

    Toyota kluger intermediate steering shaft

    Toyota kluger intermediate steering shaft

    Toyota kluger intermediate steering shaft

    Toyota kluger intermediate steering shaft

    OEM Fix for Highlander Steering Noise

    It can be scary when your steering system makes unexpected noises. Drivers might be concerned about steering failure, and about getting up close and personal with an immovable object. Steering failure is right up there with brake failure when it comes to registering fear while driving.

    Toyota knows about it and has issued the following technical service bulletin TSB to identify and correct the problem. If you see a vehicle with this condition in your shop, follow the procedures in this TSB:.

    Toyota kluger intermediate steering shaft

    A new intermediate shaft has been developed to address this condition. Use the following repair procedure to remove and replace the steering intermediate shaft. All other marks are property of their respective owners.

    Header link Heather King. June 15, Heather King. If you see a vehicle with this condition in your shop, follow the procedures in this TSB: NOTICE Prior to removing the steering intermediate shaft, make sure the steering wheel and front wheels remain stationary. Once the intermediate shaft is removed, do NOT allow the steering wheel to spin freely. Ensure the wheels are straight and the steering wheel is centered before removing the steering intermediate shaft by installing a steering wheel holder.

    Toyota kluger intermediate steering shaft

    Disconnect the steering intermediate shaft. Remove the clamp from the steering column hole shield. Separate the steering column hole cover from the cover boot. Place matchmarks on the steering intermediate shaft and steering gear assembly Figure 1. Remove the bolt and disconnect the steering intermediate shaft. Remove the steering intermediate shaft. Place matchmarks on the steering sliding yoke sub-assembly and steering main shaft assembly Figure 2.

    Remove the bolt and steering sliding yoke sub-assembly from the steering main shaft assembly. Place the corresponding matchmarks on the NEW steering intermediate shaft.

    To place the matchmarks on the NEW steering intermediate shaft place a NEW steering intermediate shaft next to the original steering intermediate shaft removed in the previous step and transfer those matchmarks to the same locations on the NEW steering intermediate shaft Figure 3.

    Toyota kluger intermediate steering shaft

    Install the NEW steering intermediate shaft. Align the matchmarks on the steering intermediate shaft assembly and the power steering main shaft assembly. Install the steering sliding yoke sub-assembly with the bolt. Align the matchmarks on the steering intermediate shaft and the steering gear assembly. Install the steering intermediate shaft with the bolt. Install the clamp to the steering column cover hole shield. Remove the steering wheel holder from the vehicle if used.

    Road test the vehicle to verify the repair and confirm that the steering wheel is centered. All other brand names and marks are the property of their respective holders.

    How to Replace Lower Intermediate Steering Shaft 07-11 Toyota Camry



    • Подписаться по RSSRSS
    • Поделиться VkontakteVkontakte
    • Поделиться на FacebookFacebook
    • Твитнуть!Twitter

    Leave a Reply

    Return to Top ▲TOP ▲